ES | E27 | Edison Screw Threaded Push Wire lampholder With 10mm Entry 95454

ES | E27 | Edison Screw Threaded Push Wire Lampholder With 10mm Entry

This ES | E27 | Edison Screw Threaded Push Wire Lampholder With 10mm Entry is the impeccable replacement for a table lamp or why not simply add a 10mm male cord grip to turn this lampholder into a pendant lampholder.

This lampholder is fully CE certified and has all the relevant documentation such as RoHS certification from the manufacturer.

The White Threaded E27 Lampholder with Push Wire Terminals comes in 2 parts. There are no screw terminals for the wires on this lampholder so your wires must have either a ferrule or be soldered so they can be pushed into the terminals. Please note that once the wires are pushed in they are not intended to be taken out again.

There are 2 options for this lampholder:

• 10mm Plastic Thread: This is all plastic this will be used if you only have a 2core cable and there is no provision for an earth cable. This does not have a locking screw so a dab of super glue may be required. 
• 10mm Metal Thread: This has a metal thread in the base with an earth connection and should only be used if you have a 3core cable with earth.

Comes with 2 additional shade rings to secure a shade into position.

Spec:

• Lamp Cap: ES | E27 | Edison Screw
• Height: 61mm
• Max Diameter For Shade: 43mm
• Min Diameter For Shade: 40mm
• Entry Thread: 10mm
• Max Wattage: 60w 
• Material: Plastic